1 # Target file name (without extension).
4 # Directory common source filess exist
5 TMK_DIR = ../../tmk_core
7 # Directory keyboard dependent files exist
10 # keyboard dependent files
18 # MCU name, you MUST set this to match the board you are using
19 # type "make clean" after changing this, so all files will be rebuilt
20 #MCU = at90usb162 # Teensy 1.0
21 MCU = atmega32u4 # Teensy 2.0
22 #MCU = at90usb646 # Teensy++ 1.0
23 #MCU = at90usb1286 # Teensy++ 2.0
26 # Processor frequency.
27 # Normally the first thing your program should do is set the clock prescaler,
28 # so your program will run at the correct speed. You should also set this
29 # variable to same clock speed. The _delay_ms() macro uses this, and many
30 # examples use this variable to calculate timings. Do not add a "UL" here.
37 # Target architecture (see library "Board Types" documentation).
40 # Input clock frequency.
41 # This will define a symbol, F_USB, in all source code files equal to the
42 # input clock frequency (before any prescaling is performed) in Hz. This value may
43 # differ from F_CPU if prescaling is used on the latter, and is required as the
44 # raw input clock is fed directly to the PLL sections of the AVR for high speed
45 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
46 # at the end, this will be done automatically to create a 32-bit value in your
49 # If no clock division is performed on the input clock inside the AVR (via the
50 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
54 # Boot Section Size in bytes
56 # Atmel DFU loader 4096
57 # LUFA bootloader 4096
58 OPT_DEFS += -DBOOTLOADER_SIZE=4096
62 # comment out to disable the options.
64 #BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
65 #MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
66 #EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
67 CONSOLE_ENABLE = yes # Console for debug(+400)
68 COMMAND_ENABLE = yes # Commands for debug and configuration
69 #SLEEP_LED_ENABLE = yes # Breathing sleep LED during USB suspend
70 #NKRO_ENABLE = yes # USB Nkey Rollover
74 # PS/2 protocol implementations
76 #PS2_USE_USART = yes # uses hardware USART engine for PS/2 signal receive
77 PS2_USE_INT = yes # uses external interrupt for falling edge of PS/2 clock pin
78 #PS2_USE_BUSYWAIT = yes # uses primitive reference code
81 #---------------- Programming Options --------------------------
82 PROGRAM_CMD = teensy_loader_cli -mmcu=$(MCU) -w -v $(TARGET).hex
86 VPATH += $(TARGET_DIR)
89 include $(TMK_DIR)/protocol/lufa.mk
90 include $(TMK_DIR)/protocol.mk
91 include $(TMK_DIR)/common.mk
92 include $(TMK_DIR)/rules.mk