1 # Target file name (without extension).
4 # Directory common source filess exist
5 TMK_DIR ?= ../../tmk_core
7 # Directory keyboard dependent files exist
10 # keyboard dependent files
21 ifdef ACTIONMAP_ENABLE
22 KEYMAP_FILE = actionmap
28 SRC := $(KEYMAP_FILE)_$(KEYMAP).c $(SRC)
30 SRC := $(KEYMAP_FILE).c $(SRC)
36 # MCU name, you MUST set this to match the board you are using
37 # type "make clean" after changing this, so all files will be rebuilt
41 # Processor frequency.
42 # Normally the first thing your program should do is set the clock prescaler,
43 # so your program will run at the correct speed. You should also set this
44 # variable to same clock speed. The _delay_ms() macro uses this, and many
45 # examples use this variable to calculate timings. Do not add a "UL" here.
52 # Target architecture (see library "Board Types" documentation).
55 # Input clock frequency.
56 # This will define a symbol, F_USB, in all source code files equal to the
57 # input clock frequency (before any prescaling is performed) in Hz. This value may
58 # differ from F_CPU if prescaling is used on the latter, and is required as the
59 # raw input clock is fed directly to the PLL sections of the AVR for high speed
60 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
61 # at the end, this will be done automatically to create a 32-bit value in your
64 # If no clock division is performed on the input clock inside the AVR (via the
65 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
68 # Interrupt driven control endpoint task
69 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
72 # Boot Section Size in bytes
74 # Atmel DFU loader 4096
75 # LUFA bootloader 4096
76 OPT_DEFS += -DBOOTLOADER_SIZE=4096
80 # *Comment out* to disable the options.
82 #BOOTMAGIC_ENABLE ?= yes # Virtual DIP switch configuration(+1000)
83 MOUSEKEY_ENABLE ?= yes # Mouse keys(+4700)
84 EXTRAKEY_ENABLE ?= yes # Audio control and System control(+450)
85 CONSOLE_ENABLE ?= yes # Console for debug(+400)
86 COMMAND_ENABLE ?= yes # Commands for debug and configuration
87 #SLEEP_LED_ENABLE ?= yes # Breathing sleep LED during USB suspend
88 #NKRO_ENABLE ?= yes # USB Nkey Rollover - not yet supported in LUFA
89 #KEYMAP_SECTION_ENABLE ?= yes # fixed address keymap for keymap editor
93 #---------------- Programming Options --------------------------
94 PROGRAM_CMD ?= teensy_loader_cli -mmcu=$(MCU) -w -v $(TARGET).hex
98 VPATH += $(TARGET_DIR)
102 include $(TMK_DIR)/protocol/lufa.mk
103 include $(TMK_DIR)/protocol.mk
104 include $(TMK_DIR)/common.mk
105 include $(TMK_DIR)/rules.mk