1 # Target file name (without extension).
4 # Directory common source filess exist
5 TMK_DIR = ../../tmk_core
7 # Directory keyboard dependent files exist
10 # keyboard dependent files
16 # To use own keymap file run make like: make keymap=hasu
18 SRC += keymap_$(KEYMAP).c
20 SRC += keymap_default.c
26 # MCU name, you MUST set this to match the board you are using
27 # type "make clean" after changing this, so all files will be rebuilt
28 #MCU = atmega32u2 # TMK converter rev2
29 MCU = atmega32u4 # TMK converter rev1
32 # Processor frequency.
33 # Normally the first thing your program should do is set the clock prescaler,
34 # so your program will run at the correct speed. You should also set this
35 # variable to same clock speed. The _delay_ms() macro uses this, and many
36 # examples use this variable to calculate timings. Do not add a "UL" here.
43 # Target architecture (see library "Board Types" documentation).
46 # Input clock frequency.
47 # This will define a symbol, F_USB, in all source code files equal to the
48 # input clock frequency (before any prescaling is performed) in Hz. This value may
49 # differ from F_CPU if prescaling is used on the latter, and is required as the
50 # raw input clock is fed directly to the PLL sections of the AVR for high speed
51 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
52 # at the end, this will be done automatically to create a 32-bit value in your
55 # If no clock division is performed on the input clock inside the AVR (via the
56 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
59 # Interrupt driven control endpoint task
60 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
63 # Boot Section Size in bytes
65 # Atmel DFU loader 4096
66 # LUFA bootloader 4096
67 OPT_DEFS += -DBOOTLOADER_SIZE=4096
71 # *Comment out* to disable the options.
73 #BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
74 MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
75 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
76 CONSOLE_ENABLE = yes # Console for debug(+400)
77 COMMAND_ENABLE = yes # Commands for debug and configuration
78 #SLEEP_LED_ENABLE = yes # Breathing sleep LED during USB suspend
79 #NKRO_ENABLE = yes # USB Nkey Rollover - not yet supported in LUFA
80 #KEYMAP_SECTION_ENABLE = yes # fixed address keymap for keymap editor
84 #---------------- Programming Options --------------------------
85 PROGRAM_CMD = teensy_loader_cli -mmcu=$(MCU) -w -v $(TARGET).hex
89 VPATH += $(TARGET_DIR)
93 include $(TMK_DIR)/protocol/lufa.mk
94 include $(TMK_DIR)/protocol.mk
95 include $(TMK_DIR)/common.mk
96 include $(TMK_DIR)/rules.mk