1 # Target file name (without extension).
4 # Directory common source filess exist
5 TMK_DIR ?= ../../tmk_core
7 # Directory keyboard dependent files exist
10 # keyboard dependent files
19 ifeq (yes,$(strip $(UNIMAP_ENABLE)))
22 ifeq (yes,$(strip $(ACTIONMAP_ENABLE)))
23 KEYMAP_FILE = actionmap
29 SRC := $(KEYMAP_FILE)_$(KEYMAP).c $(SRC)
31 SRC := $(KEYMAP_FILE).c $(SRC)
35 # MCU name, you MUST set this to match the board you are using
36 # type "make clean" after changing this, so all files will be rebuilt
37 #MCU = at90usb162 # Teensy 1.0
38 #MCU = atmega32u4 # Teensy 2.0
39 #MCU = at90usb646 # Teensy++ 1.0
40 #MCU = at90usb1286 # Teensy++ 2.0
41 MCU ?= atmega32u2 # TMK converter
44 # Processor frequency.
45 # Normally the first thing your program should do is set the clock prescaler,
46 # so your program will run at the correct speed. You should also set this
47 # variable to same clock speed. The _delay_ms() macro uses this, and many
48 # examples use this variable to calculate timings. Do not add a "UL" here.
55 # Target architecture (see library "Board Types" documentation).
58 # Input clock frequency.
59 # This will define a symbol, F_USB, in all source code files equal to the
60 # input clock frequency (before any prescaling is performed) in Hz. This value may
61 # differ from F_CPU if prescaling is used on the latter, and is required as the
62 # raw input clock is fed directly to the PLL sections of the AVR for high speed
63 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
64 # at the end, this will be done automatically to create a 32-bit value in your
67 # If no clock division is performed on the input clock inside the AVR (via the
68 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
72 # Boot Section Size in *bytes*
74 # Teensy++ halfKay 1024
75 # Atmel DFU loader 4096
76 # LUFA bootloader 4096
78 OPT_DEFS += -DBOOTLOADER_SIZE=4096
82 # *Comment out* to disable the options.
84 #BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
85 MOUSEKEY_ENABLE ?= yes # Mouse keys
86 EXTRAKEY_ENABLE ?= yes # Audio control and System control
87 CONSOLE_ENABLE ?= yes # Console for debug(+400)
88 COMMAND_ENABLE ?= yes # Commands for debug and configuration
89 #NKRO_ENABLE ?= yes # USB Nkey Rollover
95 VPATH += $(TARGET_DIR)
99 include $(TMK_DIR)/protocol.mk
100 include $(TMK_DIR)/protocol/lufa.mk
101 include $(TMK_DIR)/common.mk
102 include $(TMK_DIR)/rules.mk