1 # Target file name (without extension).
4 # Directory common source filess exist
5 TMK_DIR ?= ../../tmk_core
7 # Directory keyboard dependent files exist
10 # project specific files
20 ifdef ACTIONMAP_ENABLE
21 KEYMAP_FILE = actionmap
27 SRC := $(KEYMAP_FILE)_$(KEYMAP).c $(SRC)
29 SRC := $(KEYMAP_FILE)_plain.c $(SRC)
38 # Processor frequency.
39 # This will define a symbol, F_CPU, in all source code files equal to the
40 # processor frequency in Hz. You can then use this symbol in your source code to
41 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
42 # automatically to create a 32-bit value in your source code.
44 # This will be an integer division of F_USB below, as it is sourced by
45 # F_USB after it has run through any CPU prescalers. Note that this value
46 # does not *change* the processor frequency - it should merely be updated to
47 # reflect the processor speed set externally so that the code can use accurate
55 # Target architecture (see library "Board Types" documentation).
58 # Input clock frequency.
59 # This will define a symbol, F_USB, in all source code files equal to the
60 # input clock frequency (before any prescaling is performed) in Hz. This value may
61 # differ from F_CPU if prescaling is used on the latter, and is required as the
62 # raw input clock is fed directly to the PLL sections of the AVR for high speed
63 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
64 # at the end, this will be done automatically to create a 32-bit value in your
67 # If no clock division is performed on the input clock inside the AVR (via the
68 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
72 # This improves response of keyboard when wakeup
73 OPT_DEFS += -DSUSPEND_MODE_STANDBY
75 # Boot Section Size in *bytes*
77 # Teensy++ halfKay 1024
78 # Atmel DFU loader 4096
79 # LUFA bootloader 4096
81 BOOTLOADER_SIZE ?= 4096
82 OPT_DEFS += -DBOOTLOADER_SIZE=$(BOOTLOADER_SIZE)
86 # comment out to disable the options.
88 BOOTMAGIC_ENABLE ?= no # Virtual DIP switch configuration(+1000)
89 MOUSEKEY_ENABLE ?= no # Mouse keys(+4700)
90 EXTRAKEY_ENABLE ?= yes # Audio control and System control(+450)
91 CONSOLE_ENABLE ?= yes # Console for debug(+400)
92 COMMAND_ENABLE ?= yes # Commands for debug and configuration
93 NKRO_ENABLE ?= yes # USB Nkey Rollover
98 #PS2_USE_USART ?= yes # uses hardware USART engine for PS/2 signal receive(recomened)
99 PS2_USE_INT ?= yes # uses external interrupt for falling edge of PS/2 clock pin
100 #PS2_USE_BUSYWAIT ?= yes # uses primitive reference code
103 # Optimize size but this may cause error "relocation truncated to fit"
104 #EXTRALDFLAGS = -Wl,--relax
107 VPATH += $(TARGET_DIR)
110 include $(TMK_DIR)/protocol.mk
111 include $(TMK_DIR)/protocol/lufa.mk
112 include $(TMK_DIR)/common.mk
113 include $(TMK_DIR)/rules.mk