1 # Target file name (without extension).
4 # Directory common source filess exist
5 TMK_DIR ?= ../../tmk_core
7 # Directory keyboard dependent files exist
10 # keyboard dependent files
19 # MCU name, you MUST set this to match the board you are using
20 # type "make clean" after changing this, so all files will be rebuilt
21 # at90usb162 # Teensy 1.0
22 # atmega32u4 # Teensy 2.0
23 # at90usb646 # Teensy++ 1.0
24 # at90usb1286 # Teensy++ 2.0
28 # Processor frequency.
29 # Normally the first thing your program should do is set the clock prescaler,
30 # so your program will run at the correct speed. You should also set this
31 # variable to same clock speed. The _delay_ms() macro uses this, and many
32 # examples use this variable to calculate timings. Do not add a "UL" here.
39 # Target architecture (see library "Board Types" documentation).
42 # Input clock frequency.
43 # This will define a symbol, F_USB, in all source code files equal to the
44 # input clock frequency (before any prescaling is performed) in Hz. This value may
45 # differ from F_CPU if prescaling is used on the latter, and is required as the
46 # raw input clock is fed directly to the PLL sections of the AVR for high speed
47 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
48 # at the end, this will be done automatically to create a 32-bit value in your
51 # If no clock division is performed on the input clock inside the AVR (via the
52 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
55 # Interrupt driven control endpoint task
56 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
60 # *Comment out* to disable the options.
62 MOUSEKEY_ENABLE ?= yes # Mouse keys
63 EXTRAKEY_ENABLE ?= yes # Audio control and System control
64 CONSOLE_ENABLE ?= yes # Console for debug
65 COMMAND_ENABLE ?= yes # Commands for debug and configuration
66 #HARDWARE_SERIAL ?= yes # Use hardware serial (requires inverted serial, see README)
67 #NKRO_ENABLE ?= yes # USB Nkey Rollover
69 KEYMAP_SECTION_ENABLE = yes
72 SRC := protocol/serial_uart.c $(SRC)
73 OPT_DEFS += -DHARDWARE_SERIAL
75 SRC := protocol/serial_soft.c $(SRC)
78 # Boot Section Size in bytes
80 # Atmel DFU loader 4096
81 # LUFA bootloader 4096
82 # Bootloader size can be calculated from fuse bits
83 #OPT_DEFS += -DBOOTLOADER_SIZE=4096
89 ifeq (yes,$(strip $(UNIMAP_ENABLE)))
92 ifeq (yes,$(strip $(ACTIONMAP_ENABLE)))
93 KEYMAP_FILE = actionmap
99 SRC := $(KEYMAP_FILE)_$(KEYMAP).c $(SRC)
101 SRC := $(KEYMAP_FILE).c $(SRC)
106 VPATH += $(TARGET_DIR)
110 include $(TMK_DIR)/protocol/lufa.mk
111 include $(TMK_DIR)/protocol.mk
112 include $(TMK_DIR)/common.mk
113 include $(TMK_DIR)/rules.mk