1 # Target file name (without extension).
4 # Directory common source filess exist
5 TMK_DIR ?= ../../tmk_core
7 # Directory keyboard dependent files exist
10 # project specific files
13 protocol/serial_uart.c
19 # atmega32u4 Teensy2.0
20 # atemga32u4 TMK Converter rev.1
21 # atemga32u2 TMK Converter rev.2
24 # Processor frequency.
25 # This will define a symbol, F_CPU, in all source code files equal to the
26 # processor frequency in Hz. You can then use this symbol in your source code to
27 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
28 # automatically to create a 32-bit value in your source code.
30 # This will be an integer division of F_USB below, as it is sourced by
31 # F_USB after it has run through any CPU prescalers. Note that this value
32 # does not *change* the processor frequency - it should merely be updated to
33 # reflect the processor speed set externally so that the code can use accurate
41 # Target architecture (see library "Board Types" documentation).
44 # Input clock frequency.
45 # This will define a symbol, F_USB, in all source code files equal to the
46 # input clock frequency (before any prescaling is performed) in Hz. This value may
47 # differ from F_CPU if prescaling is used on the latter, and is required as the
48 # raw input clock is fed directly to the PLL sections of the AVR for high speed
49 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
50 # at the end, this will be done automatically to create a 32-bit value in your
53 # If no clock division is performed on the input clock inside the AVR (via the
54 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
58 # Boot Section Size in *bytes*
60 # Teensy++ halfKay 1024
61 # Atmel DFU loader 4096 for TMK Converter rev.1/rev.2
62 # LUFA bootloader 4096
64 OPT_DEFS += -DBOOTLOADER_SIZE=4096
68 # comment out to disable the options.
70 #BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
71 MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
72 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
73 CONSOLE_ENABLE = yes # Console for debug(+400)
74 COMMAND_ENABLE = yes # Commands for debug and configuration
76 #ACTIONMAP_ENABLE = yes # Use 16bit actionmap instead of 8bit keymap
77 #KEYMAP_SECTION_ENABLE = yes # fixed address keymap for keymap editor
83 ifeq (yes,$(strip $(UNIMAP_ENABLE)))
86 ifeq (yes,$(strip $(ACTIONMAP_ENABLE)))
87 KEYMAP_FILE = actionmap
93 SRC := $(KEYMAP_FILE)_$(KEYMAP).c $(SRC)
95 SRC := $(KEYMAP_FILE).c $(SRC)
100 VPATH += $(TARGET_DIR)
103 include $(TMK_DIR)/protocol/lufa.mk
104 include $(TMK_DIR)/protocol.mk
105 include $(TMK_DIR)/common.mk
106 include $(TMK_DIR)/rules.mk