4 # Target file name (without extension).
7 # Directory common source filess exist
8 TMK_DIR ?= ../../tmk_core
10 # Directory keyboard dependent files exist
13 # project specific files
14 SRC ?= protocol/xt_interrupt.c \
21 ifdef ACTIONMAP_ENABLE
22 KEYMAP_FILE = actionmap
28 SRC := $(KEYMAP_FILE)_$(KEYMAP).c $(SRC)
30 SRC := $(KEYMAP_FILE).c $(SRC)
39 # Processor frequency.
40 # This will define a symbol, F_CPU, in all source code files equal to the
41 # processor frequency in Hz. You can then use this symbol in your source code to
42 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
43 # automatically to create a 32-bit value in your source code.
45 # This will be an integer division of F_USB below, as it is sourced by
46 # F_USB after it has run through any CPU prescalers. Note that this value
47 # does not *change* the processor frequency - it should merely be updated to
48 # reflect the processor speed set externally so that the code can use accurate
56 # Target architecture (see library "Board Types" documentation).
59 # Input clock frequency.
60 # This will define a symbol, F_USB, in all source code files equal to the
61 # input clock frequency (before any prescaling is performed) in Hz. This value may
62 # differ from F_CPU if prescaling is used on the latter, and is required as the
63 # raw input clock is fed directly to the PLL sections of the AVR for high speed
64 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
65 # at the end, this will be done automatically to create a 32-bit value in your
68 # If no clock division is performed on the input clock inside the AVR (via the
69 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
73 # Boot Section Size in *bytes*
75 # Teensy++ halfKay 1024
76 # Atmel DFU loader 4096
77 # LUFA bootloader 4096
79 BOOTLOADER_SIZE ?= 4096
80 OPT_DEFS += -DBOOTLOADER_SIZE=$(BOOTLOADER_SIZE)
84 # comment out to disable the options.
86 BOOTMAGIC_ENABLE ?= no # Virtual DIP switch configuration(+1000)
87 MOUSEKEY_ENABLE ?= yes # Mouse keys(+4700)
88 EXTRAKEY_ENABLE ?= yes # Audio control and System control(+450)
89 CONSOLE_ENABLE ?= yes # Console for debug(+400)
90 COMMAND_ENABLE ?= yes # Commands for debug and configuration
91 NKRO_ENABLE ?= yes # USB Nkey Rollover
94 # Optimize size but this may cause error "relocation truncated to fit"
95 #EXTRALDFLAGS = -Wl,--relax
98 VPATH += $(TARGET_DIR)
101 include $(TMK_DIR)/protocol.mk
102 include $(TMK_DIR)/protocol/lufa.mk
103 include $(TMK_DIR)/common.mk
104 include $(TMK_DIR)/rules.mk