5 TMK_DIR ?= ../../tmk_core
7 # Location of target dependent files exist
21 # Processor frequency.
22 # This will define a symbol, F_CPU, in all source code files equal to the
23 # processor frequency in Hz. You can then use this symbol in your source code to
24 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
25 # automatically to create a 32-bit value in your source code.
27 # This will be an integer division of F_USB below, as it is sourced by
28 # F_USB after it has run through any CPU prescalers. Note that this value
29 # does not *change* the processor frequency - it should merely be updated to
30 # reflect the processor speed set externally so that the code can use accurate
38 # Target architecture (see library "Board Types" documentation).
41 # Input clock frequency.
42 # This will define a symbol, F_USB, in all source code files equal to the
43 # input clock frequency (before any prescaling is performed) in Hz. This value may
44 # differ from F_CPU if prescaling is used on the latter, and is required as the
45 # raw input clock is fed directly to the PLL sections of the AVR for high speed
46 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
47 # at the end, this will be done automatically to create a 32-bit value in your
50 # If no clock division is performed on the input clock inside the AVR (via the
51 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
54 # Interrupt driven control endpoint task
55 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
58 # Boot Section Size in *bytes*
60 # Teensy++ halfKay 1024
61 # Atmel DFU loader 4096 (TMK Alt Controller)
62 # LUFA bootloader 4096
64 OPT_DEFS += -DBOOTLOADER_SIZE=4096
68 # comment out to disable the options.
70 #BOOTMAGIC_ENABLE ?= yes # Virtual DIP switch configuration
71 MOUSEKEY_ENABLE ?= yes # Mouse keys
72 EXTRAKEY_ENABLE ?= yes # Audio control and System control
73 CONSOLE_ENABLE ?= yes # Console for debug
74 COMMAND_ENABLE ?= yes # Commands for debug and configuration
75 NKRO_ENABLE ?= yes # USB Nkey Rollover
76 #ACTIONMAP_ENABLE ?= yes # Use 16bit actionmap instead of 8bit keymap
77 UNIMAP_ENABLE ?= yes # Universal keymap
78 KEYMAP_SECTION_ENABLE ?= yes # fixed address keymap for keymap editor
80 #OPT_DEFS += -DNO_ACTION_TAPPING
81 #OPT_DEFS += -DNO_ACTION_LAYER
82 #OPT_DEFS += -DNO_ACTION_MACRO
88 ifeq (yes,$(strip $(UNIMAP_ENABLE)))
90 TARGET := $(TARGET)_unimap
92 ifeq (yes,$(strip $(ACTIONMAP_ENABLE)))
93 KEYMAP_FILE = actionmap
99 SRC := $(KEYMAP_FILE)_$(KEYMAP).c $(SRC)
101 SRC := $(KEYMAP_FILE).c $(SRC)
106 VPATH += $(TARGET_DIR)
109 include $(TMK_DIR)/protocol/lufa.mk
110 include $(TMK_DIR)/common.mk
111 include $(TMK_DIR)/rules.mk