1 #----------------------------------------------------------------------------
4 # make all = Make software.
6 # make clean = Clean out built project files.
8 # make coff = Convert ELF to AVR COFF.
10 # make extcoff = Convert ELF to AVR Extended COFF.
12 # make program = Download the hex file to the device.
13 # Please customize your programmer settings(PROGRAM_CMD)
15 # make teensy = Download the hex file to the device, using teensy_loader_cli.
16 # (must have teensy_loader_cli installed).
18 # make dfu = Download the hex file to the device, using dfu-programmer (must
19 # have dfu-programmer installed).
21 # make flip = Download the hex file to the device, using Atmel FLIP (must
22 # have Atmel FLIP installed).
24 # make dfu-ee = Download the eeprom file to the device, using dfu-programmer
25 # (must have dfu-programmer installed).
27 # make flip-ee = Download the eeprom file to the device, using Atmel FLIP
28 # (must have Atmel FLIP installed).
30 # make debug = Start either simulavr or avarice as specified for debugging,
31 # with avr-gdb or avr-insight as the front end for debugging.
33 # make filename.s = Just compile filename.c into the assembler code only.
35 # make filename.i = Create a preprocessed source file for use in submitting
36 # bug reports to the GCC project.
38 # To rebuild project do "make clean" then "make all".
39 #----------------------------------------------------------------------------
41 # Target file name (without extension).
44 # Directory common source filess exist
47 # Directory keyboard dependent files exist
50 # project specific files
58 # MCU name, you MUST set this to match the board you are using
59 # type "make clean" after changing this, so all files will be rebuilt
64 # Processor frequency.
65 # Normally the first thing your program should do is set the clock prescaler,
66 # so your program will run at the correct speed. You should also set this
67 # variable to same clock speed. The _delay_ms() macro uses this, and many
68 # examples use this variable to calculate timings. Do not add a "UL" here.
71 # Boot Section Size in bytes
73 # Atmel DFU loader 4096
74 # LUFA bootloader 4096
75 OPT_DEFS += -DBOOT_SIZE=4096
78 # comment out to disable the options.
80 BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
81 MOUSEKEY_ENABLE = yes # Mouse keys(+5000)
82 EXTRAKEY_ENABLE = yes # Audio control and System control(+600)
83 NKRO_ENABLE = yes # USB Nkey Rollover(+500)
84 CONSOLE_ENABLE = yes # Console for debug
85 #PS2_MOUSE_ENABLE = yes # PS/2 mouse(TrackPoint) support
89 VPATH += $(TARGET_DIR)
92 include $(TOP_DIR)/protocol/pjrc.mk
93 include $(TOP_DIR)/common.mk
94 include $(TOP_DIR)/rules.mk
96 plain: OPT_DEFS += -DKEYMAP_PLAIN
99 poker: OPT_DEFS += -DKEYMAP_POKER
102 poker_set: OPT_DEFS += -DKEYMAP_POKER_SET
105 poker_bit: OPT_DEFS += -DKEYMAP_POKER_BIT