@@ -40,7+40,7 @@ Move to project directory in the firmware source.
Build firmware using GNU `make` command. You'll see `<project>_<variant>.hex` file in that directory unless something unexpected occurs in build process.
Build firmware using GNU `make` command. You'll see `<project>_<variant>.hex` file in that directory unless something unexpected occurs in build process.
- mkae -f Makefile.<variant> clean
+ make -f Makefile.<variant> clean
make -f Makefile.<variant>
make -f Makefile.<variant>
@@ -71,14+71,14 @@ Or to program with `dfu-programmer` run:
#### FLIP GUI tutorial
1. On menu bar click Device -> Select, then. `ATmega32u4`.
2. On menu bar click Settings -> Communication -> USB, then click 'Open' button on 'USB Port Connection' dialog.
#### FLIP GUI tutorial
1. On menu bar click Device -> Select, then. `ATmega32u4`.
2. On menu bar click Settings -> Communication -> USB, then click 'Open' button on 'USB Port Connection' dialog.
-At this point you'll see greyouted widgets on the app get colored and ready.
+At this point you'll see grey-outed widgets on the app get colored and ready.
3. On menu bar click File -> Load HEX File, then select your firmware hex file on File Selector dialog.
4. On 'Operations Flow' panel click 'Run' button to load the firmware binary to the chip. Note that you should keep 'Erase', 'Blank Check', 'Program' and 'Verify' check boxes selected.
5. Re-plug USB cord or click 'Start Application' button to restart your controller.
Done.
3. On menu bar click File -> Load HEX File, then select your firmware hex file on File Selector dialog.
4. On 'Operations Flow' panel click 'Run' button to load the firmware binary to the chip. Note that you should keep 'Erase', 'Blank Check', 'Program' and 'Verify' check boxes selected.
5. Re-plug USB cord or click 'Start Application' button to restart your controller.
@@ -95,7+95,7 @@ Or use this command if you have command line version of Teensy Loader installed.
### 4. Program with Other programmer
### 4. Program with Other programmer
-You may want to use other programmer like `avrdude` with AVRISPmkII, Aruduino or USBasp. In that case you can still use make target `program` for build with configuring `PROGRAM_CMD` in Makefile.
+You may want to use other programmer like `avrdude` with AVRISPmkII, Arduino or USBasp. In that case you can still use make target `program` for build with configuring `PROGRAM_CMD` in Makefile.
$ make -f Makefile.<variant> program
$ make -f Makefile.<variant> program
@@ -132,9+132,10 @@ Optional. Note that ***comment out*** to disable them.
COMMAND_ENABLE = yes # Commands for debug and configuration
SLEEP_LED_ENABLE = yes # Breathing sleep LED during USB suspend
#NKRO_ENABLE = yes # USB Nkey Rollover - not yet supported in LUFA
COMMAND_ENABLE = yes # Commands for debug and configuration
SLEEP_LED_ENABLE = yes # Breathing sleep LED during USB suspend
#NKRO_ENABLE = yes # USB Nkey Rollover - not yet supported in LUFA
-Optional. Set proper command for your controller, bootloader and programmer. This command can be used with `make program`. Not needed if you use `FLIP`, `dfu-programmer` or `Teesy Loader`.
+Optional. Set proper command for your controller, bootloader and programmer. This command can be used with `make program`. Not needed if you use `FLIP`, `dfu-programmer` or `Teensy Loader`.