- **USART**: **Clock** is on `PD5` and **Data** on `PD2`.
3. Optionally you need pull-up resistor. 1K-10K Ohm is OK.
-To change pin configuration edit config.h.
+To change pin configuration edit **config.h** and **Makefile**.
Build Firmware
V-USB Support
-------------
-You can also use this converter on ATmega(168/328) with V-USB instead of Teensy.
-The converter on V-USB lacks some features for now: USB NKRO and System/Media control.
+With V-USB you can use this converter on ATmega(168/328) but it doesn't support NKRO at this time.
Circuit: