Add a qwerty layer

[max/tmk_keyboard.git] / hhkb / Makefile

diff --git a/hhkb/Makefile b/hhkb/Makefile
deleted file mode 100644 (file)
index 980980c..0000000
--- a/hhkb/Makefile
+++ /dev/null
@@ -1,72 +0,0 @@
-# Hey Emacs, this is a -*- makefile -*-
-#----------------------------------------------------------------------------
-# WinAVR Makefile Template written by Eric B. Weddington, Jörg Wunsch, et al.
-#
-# Released to the Public Domain
-#
-# Additional material for this makefile was written by:
-# Peter Fleury
-# Tim Henigan
-# Colin O'Flynn
-# Reiner Patommel
-# Markus Pfaff
-# Sander Pool
-# Frederik Rouleau
-# Carlos Lamas
-#
-#----------------------------------------------------------------------------
-# On command line:
-#
-# make all = Make software.
-#
-# make clean = Clean out built project files.
-#
-# make coff = Convert ELF to AVR COFF.
-#
-# make extcoff = Convert ELF to AVR Extended COFF.
-#
-# make program = Download the hex file to the device, using avrdude.
-#                Please customize the avrdude settings below first!
-#
-# make debug = Start either simulavr or avarice as specified for debugging, 
-#              with avr-gdb or avr-insight as the front end for debugging.
-#
-# make filename.s = Just compile filename.c into the assembler code only.
-#
-# make filename.i = Create a preprocessed source file for use in submitting
-#                   bug reports to the GCC project.
-#
-# To rebuild project do "make clean" then "make all".
-#----------------------------------------------------------------------------
-
-
-# Target file name (without extension).
-TARGET = tmk_hhkb
-
-# Directory common source filess exist
-COMMON_DIR = ..
-
-# Directory keyboard dependent files exist
-TARGET_DIR = .
-
-# keyboard dependent files
-TARGET_SRC =   keymap.c \
-               matrix.c
-
-
-# MCU name, you MUST set this to match the board you are using
-# type "make clean" after changing this, so all files will be rebuilt
-#MCU = at90usb162       # Teensy 1.0
-#MCU = atmega32u4       # Teensy 2.0
-#MCU = at90usb646       # Teensy++ 1.0
-MCU = at90usb1286      # Teensy++ 2.0
-
-
-# Processor frequency.
-#   Normally the first thing your program should do is set the clock prescaler,
-#   so your program will run at the correct speed.  You should also set this
-#   variable to same clock speed.  The _delay_ms() macro uses this, and many
-#   examples use this variable to calculate timings.  Do not add a "UL" here.
-F_CPU = 16000000
-
-include $(COMMON_DIR)/Makefile.common